How To Hook Up A Plug Switch Combo. The other two wires carry power from switch to In the third case, the switch controls both the outlet and the light.
Switch / Outlet Combo Outlet Always On Electrical from www.diychatroom.com
The wires that hook to the common terminals should be connected first. Verify the load and line terminals while installing a gfci for protection. The black cable wire runs from the switch to the bottom half of the outlet.
On The New Gfci/Switch Combo There Is A Load And Line Side, And Two Black Wires Coming Out Of The Back That Are Meant To Control The Switch.
We hooked the black wire to the line side of the outlet,brass screw, and the white wire to the line side, silver screw. In the third case, the switch controls both the outlet and the light. In the old one there are two wires coming into the line side, a hot wire and a neutral.
This Is Called A Pigtail.
To connect the switches, simply score the wire with your wire stripper and push the insulation to expose about 3/4 in. Unplug the power supplies of cable modem, switch and wireless router. Look for the darkest of the three terminals, this is the common.
To Wire This Circuit, The Source Wires Are Connected To The Line Terminals On The Receptacle Half Of The Combo.
Use the correct polarity i.e. Amazon prime student 6 month free trial: The other switch wire is connected to the load hot terminal on the combo device.
Connect The Other Ends Of The Extra Lengths To Both The Bronze Terminals On The Same Side Of The Combination.
Keep the two wires together because you’ll need to create a pigtail, which involves connecting multiple wires together with a wire nut in order to turn two or more wires into a single connection that you can then connect to the switch’s screw. To do this, simple remove the breakaway fin between the line terminals and connect the upper terminal to source one and the lower line terminal to source two. The black cable wire runs from the switch to the bottom half of the outlet.
In This Configuration The Outlet Only Works When The Switch Is On.
We have a black, white and ground wires (the line) and a black and white wire (these are soft lines for the light) coming out of the receptacle. Verify the load and line terminals while installing a gfci for protection. The wires that hook to the common terminals should be connected first.
Share
Post a Comment
for "How To Hook Up A Plug Switch Combo"
Post a Comment for "How To Hook Up A Plug Switch Combo"